Cardone Reman 18-8100 Disc Brake Caliper For FORD,INTERNATIONAL

Buy Part Now

ShowMeTheParts has a wide selection of Cardone Reman products for a variety of years, makes, and models.

Cardone Reman 18-8100 Disc Brake Caliper For FORD,INTERNATIONAL

BUYERS GUIDE

Make Model Year Engine
FORDF-6502009-13All
FORDF-6502009-13All
FORDF-6502009-13All
FORDF-6502009-13All
FORDF-6502015All
FORDF-6502015All
FORDF-6502015All
FORDF-6502015All
FORDF-7502009-13All
FORDF-7502009-13All
FORDF-7502009-13All
FORDF-7502009-13All
FORDF-7502015All
FORDF-7502015All
FORDF-7502015All
FORDF-7502015All
INTERNATIONAL41002009-11All
INTERNATIONAL41002009-11All
INTERNATIONAL43002009-13All
INTERNATIONAL43002009-13All
INTERNATIONAL44002009-11All
INTERNATIONAL44002009-11All

PART INFORMATION

Brand:Disc Brake Caliper by Cardone Reman For FORD,INTERNATIONAL | ShowMeTheParts.com
Part Number:188100
Part Type: Disc Brake Caliper
Comment:Expertly remanufactured to rigorous quality and performance standards, all CARDONE Brake Calipers are equipped with brand-new, premium components to guarantee exceptional longevity and reliability. These remanufactured brake calipers are 100% pressure-tested to deliver consistent, industry-leading brake performance. Each unit arrives with a complete set of brand-new hardware for a simple, complete installation. Caliper bracket is included when applicable.

PARTS ATTRIBUTES

Name Value
Abutment Clips IncludedNo
Anti-Rattle Spring IncludedYes
Average Current DrawCar pulls to one side during braking. Why?
Average Current Draw (Ampere)Brake squeal can be caused by improper installation of the brake pads, improperly installed brake hardware and improper brake rotor finish.
Bleeder Screw Cap IncludedNo
Bleeder Screw IncludedYes
Bleeder Screw Quantity2
Bleeder Thread Size7/16x24
Bracket IncludedNo
Caliper ColorGray
Caliper FinishOil Emulsion
Caliper Slides IncludedYes
Caliper TypeFloating
Casting Number595-M
Contains Electronic ComponentsNo
Country of OriginUnited States
Disc Brake Caliper Casting MaterialCast Iron
Does it require SDSNo
Dust Boots IncludedYes
E-WasteNo
End 2 Fitting GenderYes
End To End Length (Inch)Oil Emulsion
End To End Length (Millimeter)Cast Iron
FAA_A1Not recommended. The O.E. manufacturers specified steel or phenolic pistons based on the intended use of the vehicle. It is recommended that the installer follow the manufacturer’s recommendations.
FAA_A2As a rule, always use brake fluid recommended by O.E. The fluid type is stamped on the master cylinder reservoir lid. Always use new fluid in a sealed container.
FAA_A3Inspect both calipers for binding or sticky slides or pins. Also ensure that brake hoses are not collapsed or restricted and inspect steering/suspension components for proper operation.
FAA_A4Brake squeal can be caused by improper installation of the brake pads, improperly installed brake hardware and improper brake rotor finish.
FAA_A5A symptom of a low brake pedal is usually caused by air in the system, misadjusted rear brake shoes, deteriorated brake hose(s) or a defective master cylinder.
FAA_A6A silicone grease is used on floating caliper mounting pins.
FAA_A7New hardware is included with all of our Calipers however the mounting bracket is an added option depending on part number and application. Mounting Brackets are also sold separately for most applications.
FAQ_Q1Can I switch out a Phenolic Piston Caliper for a Steel Piston Caliper or vice versa?
FAQ_Q2What type of fluid should I use: DOT 3, DOT 4, or DOT 5?
FAQ_Q3Car pulls to one side during braking. Why?
FAQ_Q4Brakes squeal all of the time. What's causing the squeal?
FAQ_Q5Could calipers be the cause of a low brake pedal?
FAQ_Q6What type of grease is used on floating caliper mounting pins?
FAQ_Q7Do all of your Calipers come with the new hardware and a mounting bracket for installation?
Flash Programming RequiredNot recommended. The O.E. manufacturers specified steel or phenolic pistons based on the intended use of the vehicle. It is recommended that the installer follow the manufacturer’s recommendations.
Fuel Filter IncludedYes
Grade TypeRegular
Hardware IncludedWhat type of grease is used on floating caliper mounting pins?
Hazardous MaterialNo
Height - Each (Inch)7.3750
Housing Height (In)Inspect both calipers for binding or sticky slides or pins. Also ensure that brake hoses are not collapsed or restricted and inspect steering/suspension components for proper operation.
Housing IncludedCan I switch out a Phenolic Piston Caliper for a Steel Piston Caliper or vice versa?
Housing Width (in)As a rule, always use brake fluid recommended by O.E. The fluid type is stamped on the master cylinder reservoir lid. Always use new fluid in a sealed container.
Inlet Fitting TypeFlare
Inlet Port Quantity2
Inlet Port Size (Inch)0.437
Inlet Port Size (Millimeter)11.09543
Inlet Thread Size7/16x24
Input Shaft Diameter (Inch)No
Input Shaft Diameter (Millimeter)Yes
Input Shaft Spline QuantityYes
Is Item A ChemicalNo
Is Or Contains A BatteryNo
Is Or Contains A BulbNo
Is Prop Sixty Five AffectedNo
Is the item CARB affectedNo
Item Level GTIN00884548081802
Length (in)7/16x24
Length - Each (Inch)17.8750
Life Cycle StatusAvailable to Order
Linkage Frame or BracketA symptom of a low brake pedal is usually caused by air in the system, misadjusted rear brake shoes, deteriorated brake hose(s) or a defective master cylinder.
Material Thickness (mm)Could calipers be the cause of a low brake pedal?
Maximum Gauge Diameter (in)Yes
Minimum Gauge Diameter (in)Yes
Motor IncludedCar pulls to one side during braking. Why?
Mounting Bolt IncludedNo
Mounting Bracket IncludedNo
Mounting Hardware IncludedYes
Mounting Hole DiameterYes
Mounting Hole Diameter (Inch)0.613
Mounting Hole Diameter (Millimeter)15.56407
Mounting Hole Thread Diameter (Inch)0.613
Mounting Hole Thread Diameter (Millimeter)15.56407
Outlet Fitting Thread Size (Millimeter)Yes
Output Shaft Diameter (Inch)7/16x24
Output Shaft Diameter (in)Oil Emulsion
Output Shaft Diameter (mm)Cast Iron
Package ContentsCaliper; Instruction Sheet; Hardware Kit
Pad Wear Sensor IncludedNo
Pads IncludedNo
Piston Diameter (Inch)2.753
Piston Diameter (Millimeter)70
Piston MaterialPhenolic
Piston Quantity4
Plug and PlayBrake squeal can be caused by improper installation of the brake pads, improperly installed brake hardware and improper brake rotor finish.
Product ConditionRemanufactured
Pulley Attachment Type2
Quantity Per Application1
Resistance Ohms Full (PSI)2
Rust Resistant CoatingYes
Strainer Fitting Diameter (Millimeter)Can I switch out a Phenolic Piston Caliper for a Steel Piston Caliper or vice versa?
TypeNew hardware is included with all of our Calipers however the mounting bracket is an added option depending on part number and application. Mounting Brackets are also sold separately for most applications.
WarrantyNew hardware is included with all of our Calipers however the mounting bracket is an added option depending on part number and application. Mounting Brackets are also sold separately for most applications.
Weight - Each (Gross Pounds)36.0200
Width (in)No
Width - Each (Inch)10.5000
Wire Gauge MeasurementCaliper
Wire Or Terminal QuantityYes
Buy Part Now
Top